SpudFiles

I did the same acouple years back. Though fields down here don't allow liquid ammo. Have to use nerf pocket rockets, an if a ref ant there. No one calls it.

Best i found for launching paint ballons is lube the barrel. An use some foam for a wadding. Green stuff from wal-mart craft section works ...

Here is a trip wire mine I made up acouple of years ago. Mostly 3/4 pipe an fittings. Breech opening is made of 1 inch female and cap with a 3/4 section inside for spring gidance. An a 1 inch male to 3/4 adapter, Springs an all material i found at home depot. Plunger head is a 12 gram co2 end i cut ...

here is acouple Ideas for paintball RPG

http://www.spudfiles.com/forums/break-d ... 18189.html

http://www.spudfiles.com/forums/paintba ... 18118.html

yes you can. Redrill holes at angles, an put in 8 an make them smaller. Thee angle will help, but the smaller holes increase pressure. Cover more area.

Another reason why trip wires are better. Nobodys foot can cover it all

Yea i bought one three years back, and made ten more. Replace the top of the plunger with a 2inch to 1/2 reducer. Will make the trigger surface area much bigger.

I stopped using mines because you have to fill bury and they might get stepped on. Trip wire mines are much easier for set up, and a trip ...

Yea I saw that one. Personally I like this one, a ground up build to what ever size you want.



I have some more body work to finish up on my camaro. But once i am done it will be main gun, then MLRS. Consturct the tank to fit the weapons.

Yea it would be. Right to the point that it over shoots someone, they get mad. Walk over and kick it to oblivion.

I have been wanting to build a Paintball Armoured Vehicle. Been thinking of a M1 Abram design. A sprinkler valve for the main cannon, piston valve MLRS mounted in the ammo rack area ...

It is dumb right up to the the point you adapt it. Yeap. Currnetly planning out a nine tube, 2" barrel, 1" piston valve MLRS. I have two dc motors actually JVA Jandy Valve Actuators. These are used to open valves on pools.

Can we say computer controled launcher.

I agree use a palmer regulator. This is the setup i used.
http://www.spudfiles.com/forums/paintba ... 18118.html
Works well for me.

So could the same trigger set up be used to fire off nine piston valves. For a single trigger in a nine tube mlrs.

Yes for taking out tanks or bunkers.

Yea was one of my first designs I built. I use a screw an notch system to keep it together. Great for running with alot of gear, and this on my hip. Slow reload though.

A single 12gram co2 nerf launcher.

About 6-7 pounds with co2, 3-4 with out tank on a bathroom scale. I like that it came out with a nice center of balance.

Mainly i just shoot the nerf rockets. First ever was a 3 inch mortar that shot paint filled water ballons. Since paint fields went to no liquid ammo.

I am now to just RPG ...

Thank you. I made it short cause i carry so much stuff when i play. I wanted something light, compact an still had good range. For now it is a happy medium, till next time I get bored.

Running it at 95 psi. which is sending the rounds 100 - 120ft with a good arch.