ok i got it to work better i just took a file and smoothed out that little white nipple below the solenoid but i was not able to get out to get a blowgun today, we got like 11 inches of snow but saturday i will go and get a blowgun and mod it because now it honks which is sorta annoying but other ...

ok i think i have figured out where the air is leaking its leaking though the little hole drilled into the exit side of the valveif i put my finger over it and pump it to 20 psi then it works but it still leaks through the small hole. this means i should get a blowgun tomorrow right?

well today i went out and bought a sprinkler valve and i cannot get it to seal. i am using just the normal solenoid to actuate it. i took it off and when i blow in it air just leaks out. any tips?

http://www.partsamerica.com/ProductDeta ... mber=M4134

shows a max of 60 psi

tomorrow im going to go out to home depot and menards, what section would the threaded schrader valves be under if they carried them

it says on the manufatctuer website and on the auto parts website

i would just feel better using a threaded schrader valve because the pop in ones are only rated to 60 psi

does home depot carry these schrader valves or would a auto repair shop have them like checker and autozone

http://www.partsamerica.com/ProductDeta ... mber=V4130

something like this right?

yea except i dont have a lowes in the area. so that sucks

and where would you find them in home depot cause their website sort of sucks

where locally could i purchase a threaded schader valve i was looking at an auto store but could not find anything.

also is this a good sprinkler valve
http://www.homedepot.com/
and enter in 162344 in the search

this is for my first pneumatic, what is a good size pipe for a bike pump to pump ...

well tonight i was slightly bored so i decided to throw toghether a not so mini mini.
the chamber is 7 inches of 1.5in sch40 pvc with a screwon adapter to 54inches of .5 inch havent gotten around to shooting it but ammo will probably be potatoes and my rolled magazine darts for delivering nails and ...

how about 2 semicircles with a rod trough the center of the chamber so you would get maximum flow i dont know how you would go about ressetting it though?

well yea i just did this quick i was too lazy to go all the way downstairs to run a 2nd trial to get a screenshot

what PT's did you get i got the ones paired with a ir led and used the ir led's to make a IR nightvision camera but thats a whole other story. if you want i could post up a wav file of ...

this is a shot from my .5 inch blowgun i was using paper darts and it was shot about 4 feet underneath a 60 watt flood light

i have made one and its about 3 ft tall with about a 4ft arm
to adjust the pin just take an straight screw (skinny is easier) screw it into the end of the arm and then cut off the nub end? then take a pliers and just bend it up and test

i tested it inside underneath a 100 watt bulb and i made the holes to let the light into the PTs pretty big.

i think that if you have it too close to the light the intensity of the light makes it difficult to tell between spikes and normal graph