From time to time I come back to see how the forum is doing and I always check this thread , and now when there is something new , the pics don't show up If there is a place where I can check out your work please share it

Looks very nice and steady. The only problem would be if you have to move it . I envy you with my 30 sm piece of train rail. Can't wait to see some knives (or other stuff) forged on this thing.

im not sure if this would help you, but i was shooting .22 with 30-15 bars, and i used 11.7 grain pellets. They pierced trough tin can at 20 m (except the last shots at 18-15 bars)

warhead052 - I'm from Bulgaria and here, in almost every online weapon store there are HATSAN 125 barrels for 22 euros and HATSAN AT 44 for 40 euros ( 125 is for break barrel, at44 is for pcp) Dont you need special documents to buy a barrel ? Please post a link with a barrel for sale. I am looking ...

I have a short question - is it dangerous to grease my airtank(200 bar) with silicone grease from inside to prevent it from rusting

oi , here something small

Hello again, its time for the third upgrade of my rifle. Now it has 200 bar air tank, new trigger and everything is fixed with screws - no more resin or soldering. Its much more powerful now , but also very loud. It weights 3 kg , 80 cm. long. The air tank is from hatsan at44 180cubic centimeters. I...

Hi guys, im looking fo a metal tube 8 or 9 mm outer diameter, inner - the smaller - the better , i need it for 2stage pump like this http://www.spudfiles.com/resources/plea ... r-in/11515. (the red part) Any ideas where can i find something like that?

Here's my first try on knives. Its made out of an old file. Blade - 180 ,handle - 130 ,thickness - 7 mm . For now im too lazy to make saya . And a keyholder just for the lulz

Second, after the hammer strike, it will stay in the position that pushes open the gas valve causing the gase in the reservoir to empty, wasting most of the gas. this problem, however can be overcomed by using a spring that is slightly shorter than the length of the hammer housing, so the hammer st...

Oi, i have a question. I am making a hand pump for my rifle and Im not sure how to make the check valve. For now im using a cone head screw and O-ring.(on the picture ) The screw is 4mm and the hole is 4mm, and when i pump up to 30 bars it gets realy hard to pump more. And im not sure if its just be...

It looks like the bow is very easily pulled and the shot is weak. Isn't it better idea to make a bow out of polyester resin and fiberglass ?

Its second hand. 15 euro for the barrel and 3 for the shipment. Good that I found the bulgarian field target forum.

Hello again guys, its time for the third revision of my rifle (now i can legitimately call it this way) I changed the barrel with 5.5 mm from Hatsan AT44. I was planning to buy 6.25, but i found this one for a very good price. Then i had to change the whole receiver to fit the new barrel. I replaced...

Yep, i'm watching the progress of your project with interest. 200 psi is too much, 120 - 140 is more realistic, but my final goal is 40 bars i hope it wont explode in my face if i manage to get this pressure