alright i'll try it, i got some liquid electrical tape.

but those are pretty big i need a system that's smaller one i can wear on my waist.

well i got the sidac and it works. its gotta a really good cyclical rate with the cap that's already in there. but still not getting any where near your power. the spark wont jump more then the space between the terminals that are already there. any way i can make more powerful spark. i tried ...

you mean the charging circuit cause it shouldn't be a problem. the cap that's in there is already 400. and in my first stun gun configuration i had three 350v caps wired in to so.

well i was going to chain 2 sidac's together 2 give me a discharge voltage of 480. i mean i got five of them so?

so if i put them in series would the capacitance be to low at 0.05?

okay so i went and exchanged those for two 0.1uf 250 volt caps. i figure ill just chain them together for 500 volts. can you refresh my memory if i want to increase voltage do i run them in parallel or series? also do you think that will work?

its cool, i saved the recite ill take it back tomorrow

i also hit up radio shack and got some 500v 0.0047uf capacitors to replace the ones in the circuit. but there really small. did i fuck up and get ones that wont work. i know Zeus said 0.1 to 0.47 but i didn't notice the extra zeros in mine till i got home. are they too small or will they give me a ...

thanks for all the help hotwired I'm ordering them now.

i know but the only sidac i could find on eBay was that 240 one. umm where did you get yours if you don't mind me asking?

that sites no good charge a minimum order of 20 bucks. how about this one http://www.ebay.com/itm/MKP3V240-SIDAC-Hi-Voltage-240V-Bilateral-Triggers-5-/370403866408?pt=LH_DefaultDomain_0&hash=item563dca7728 think that will work? voltage is a little low but i do get 5 so i can chain 2 together and ...

that sites no good charge a minimum order of 20 bucks. how about this one http://www.ebay.com/itm/MKP3V240-SIDAC-Hi-Voltage-240V-Bilateral-Triggers-5-/370403866408?pt=LH_DefaultDomain_0&hash=item563dca7728 think that will work? voltage is a little low but i do get 5 so i can chain 2 together and ...

well either way i might as well go with this since i gotta buy online anyway.
http://il.farnell.com/jsp/search/productdetail.jsp?sku=1827763 what do you think will it get the job done, the data sheet for its in a link on the page right next to the pic. thanks for all the help on this everyone. also ...

Most of those type diacs are used to trigger triacs in a light dimmer. As such they have a typical breakover voltage of somewhere between 6 and 20 volts. They are a trigger device, not a power switching device. Use with an SCR or TRIAC to get the higher voltage desired.

Edit. I looked up the data ...