Only have 8 post, can't vote yet. Northern Cailfornia USA

Voltage alarms usually plug into balance port connector. Not sure about splitter, but should work. Seen plans out on the web for switching parallel to series ( 7.4v to 14.8v) for higher rate of fire. Mosfet is recommended to save trigger contacts.

The 7.4 4000 mah seems ok. Check out Hobbyking.com, I buy my lipo there, also noticed they are a sponsor of this forum. As for internals, stock stuff is fine. Recommend you do some reading on airsoftforum.com. Shim, correct AOE, seal air leaks.

Deans are a recommended upgrade. Hope your lipo is at least 20c or better. 2200 mah should last you for an all day event. If your going to use a 11.1v, have you gone thur your gearbox and done all the tweaks? Also a mosfet is recommended to prevent trigger contacts from burning out. You may want to ...

Thanks. Looks like I will be reading alot of info. Hoped for a prebuilt module that would interface a blue tooth headset to my radio with minor tweaking. Radio just has standard analog mic/speaker jacks. Wanted to use a manual push to talk setup.

The talk about a bluetooth ignitor got me wondering. Is there be a way to build a inexpensive bluetooth receiver for a two way radio? Wanted to use a bluetooth headset with my two way radio. Would someone point me in the right direction. Web search just turn up off the shelf units.

Kinda hard to see in pictures.
Wires from the gray sheild probably supply power to compressor.
Wire that is green with yellow trace is ground.
Upper wire ? light blue wire, hard to see with glare, is possibly common.
Lower wire? tan wire, again hard to see from glare is possibly hot lead.
There ...

100 feet range is perfect for airsoft. Would like to see more detail on valve.

Been lurking on the forum for awhile. Also building an m72 style nerf launcher. Would sch80 2" pvc pipe with id of 1.913" be too tight of a fit? Only have 3 nerf vortexs to sample, they range in size 1.930" to 1.970"