indeed it needs a lot more sanding.I was thinking I could galvanize the metal parts to prevent rust. I just need to find some time to finish it.

This airgun works very well at 40 bar, haven't tested it over 50 though.
Finland66 - why so much pressure ? what will you fire with it ?

hy there, sorry for the long time since my last post, but i've been busy at work, and with my new airgun project, it's not done yet, i still have some work to do, but anyway here's a picture. http://s15.postimg.org/zeb3tlenf/CAM00333.jpg all i have to say is that it's the same principle as my last a...

no video in semi-auto yet, i'm having trouble with the return of the DCV's rod, and i'm waiting for the o-rings to wear off a littlebit, hoping that the rod will move much smoother :roll: the weird sound is from the exhaust of the QEV, because i forced it to exit through 2 small holes (the original ...

jackssmirkingrevenge wrote:Sweet, can't wait to see this thing work. Does it feed correctly, is the magazine side mounted?

free photo hosting

http://youtu.be/0w9ygH_zqlo http://youtu.be/nOBfILAhE34 http://s18.postimage.org/fmckhhn6x/CAM00179.jpg photo sharing websites http://s7.postimage.org/ejztd99bv/CAM00180.jpg online photo storage http://s1.postimage.org/pj17q5shr/CAM00181.jpg upload foto did some testd today at my workshop, and the p...

i had a small rubber cilinder with a 5.95mm hole from a BB toy gun, wich i could use to stop the bb from rolling out, but i lost it and i`m not going to buy another toy for it , especialy if i wont use pvc BB`s

MRR, what do you fire with that thing ? I use 6mm rollbearing BB”s and at the base of the of the loader i put a very strong magnet that pulls and keeps the bb in position in the barrel. the loader has a aprox. 10 BB capacity. if i use pvs BB”s (airsoft) I have to load 1 by 1 manualy after each shot....

for now the air source is a 1 litre freon tube (50 bar resistant) that I filled with compressed air using a refrigerator motor (compressor). in the near future i will connect my gun to a 2 litre co2 tube(wich i have trouble filling because it's to small and it's difficult to fill ) http://s4.postima...

image sharing


free image hosting

i wll make a video when i go in the country. there is no way i go in the street with this

if I”d buy the components ready made where would the fun and self satisfaction be ?? the 3/8 bras fittings didn't cost me more than 10 bucks, and all the other necessary adjustments where made on a lathe. Eveything is done, the mechanism works perfect, no leaks, tested it on approximately 30 bar (43...

here is my project , I have a little more work but I hope to make some photos when it”s ready