Search found 8 matches

Return

by Theonepbs
Tue Dec 29, 2020 11:40 pm
Jump to forum
Jump to topic

3D printing?

7A310B0F-7133-45BD-850D-6A43AFB70666.jpeg Hello all I appear new to the forums, but I’m really not! I have been on here since dial up internet, and the spud tech site forums. Anyhow I stop in now and again to see what’s new here, and what badass things you creators have made! With that being said, ...
by Theonepbs
Wed Jan 06, 2021 10:51 am
Jump to forum
Jump to topic

Re: 3D printing?

Thanks everyone I didn’t even realize I had got reply’s until just now! Yes i was going for a coaxial design the small groves were to allow the chamber to be filled past the piston or an equalization channels as there is none on the piston itself and a spring would also be used to aid in the sealing...
by Theonepbs
Thu Feb 04, 2021 10:23 pm
Jump to forum
Jump to topic

so more 3d printing ideas for review

so i drew up my own version of a tippmann X-valve the heart of most of the tippmann line in paintball 98, 98c, a5, etc anyhow its way bigger by design there suppose to sit inside 1.5" pvc the face where the hammer hits to work the valve is the same size as 1.5" pvc and fits inside a 1.5 pvc pipe cou...
by Theonepbs
Wed Sep 22, 2021 10:14 pm
Jump to forum
Jump to topic

Some 3d printed ammo

So been gone for awhile but I am back for a min here is some ammo I 3d printed on a whim I’ll post more pics to this post when I locate the others mostly 68 cal But this guy is 1.5” diameter / 39mm And no it is not just plastic ( PETG) in This case I based the design some what in a first strike roun...
by Theonepbs
Thu Sep 23, 2021 11:06 pm
Jump to forum
Jump to topic

Re: Some 3d printed ammo

ok i found some more photos of stuff I have printed recently, and a cannon I made awhile back also one I printed

note: spring loaded finned projectiles red and grey for size comparison the one on the left in the picture showing 2 different ones is 12g i have alot more but am still locating them
by Theonepbs
Tue Oct 05, 2021 7:43 pm
Jump to forum
Jump to topic

Re: Feedback for an idea I just had

here is a link to an example of a clamp on stock for 2" pvc pipe including space for an end cap or fitting i just modeled up


https://a360.co/3iyCXeE
by Theonepbs
Wed Oct 27, 2021 1:58 pm
Jump to forum
Jump to topic

Re: Rapid firing air cannon?

I have all there plans from many years ago before they sold the site i will look for them and post them if that's allowed since there out of business
by Theonepbs
Sun Oct 31, 2021 1:12 am
Jump to forum
Jump to topic

Re: Rapid firing air cannon?

i have found the plans and will upload them shortly I have been busy trying not to lose everything but I wanted to post an update so your not left hanging ill probably take pics of them and upload them that way it will be the easy way t save etc. I also have a few others I may upload like the PAC 6 ...