Teflon lined barrel

Potatoes last one shot, so build reusable! Discuss ammo designs and ideas. Tough to find cannon part or questions? Ask here!
Posts: 1
Joined: Tue May 17, 2022 12:45 pm

Tue May 17, 2022 12:48 pm


I noticed that teflon and steel have a very low friction constant (0.05), and I was wondering if you could line a barrel with teflon (or make a barrel entirely out of teflon) and reach higher velocities than with a steel barrel (friction steel vs steel is 3x higher than steel vs teflon). Has anyone ever tried this? Or would the effect not be noticable?
Sergeant Major
Sergeant Major
United States of America
Posts: 3187
Joined: Wed Mar 28, 2007 9:48 am
Location: Greenwood, Indiana
Has thanked: 1 time
Been thanked: 11 times

Thu May 19, 2022 11:23 pm

Lower barrel friction might actually lower cannon performance. For combustion cannons the friction (especially the static friction) contributes a lot to performance by holding the ammo in position long enough for combustion to proceed and pressure to build. Combustion is actually a pretty close process.

For pneumatics, friction will give the valve more time to fully open.
Post Reply