Page 1 of 1
working on a valve
Posted: Tue Jan 16, 2007 1:38 pm
by imforcedtodothis
i plan to make a valve like this one:
http://www.geocities.com/izzydoesit_99/YASLA.html
where could i find the rubber disk, metal disk and spring?
also,a goyen high flow valve behind the piston be better than just a blowgun, right?
Posted: Tue Jan 16, 2007 1:43 pm
by iknowmy3tables
go to Mcmaster.com they have every thing you need its where all the spudgunners go for these kind of parts
Posted: Tue Jan 16, 2007 1:55 pm
by imforcedtodothis
all i can find is rods, not disks.
Posted: Tue Jan 16, 2007 2:08 pm
by imforcedtodothis
if i got a rubber rod how would i go about cutting a disk off of it?
Posted: Tue Jan 16, 2007 6:54 pm
by rna_duelers
Rubber rod?I think you would want sheet rubber not rubber rod or neoprene as it is comonly called.Just go to a hardwear store and have a look around.
Posted: Tue Jan 16, 2007 7:11 pm
by jrrdw
Hardware store = pluming department = sink parts = washer bin = rubber washer.
Thats the steps i rolled when i needed a sealing washer, worked for me.
Posted: Tue Jan 16, 2007 8:47 pm
by imforcedtodothis
rna_duelers wrote:Rubber rod?I think you would want sheet rubber not rubber rod or neoprene as it is comonly called.Just go to a hardwear store and have a look around.
well you'd need a circle thats pretty perfect for an airtight seal and they dont have what i want in disks. i think ill just go with the washer.