Page 1 of 1
Drill bit shank?
Posted: Sat Apr 26, 2008 11:28 pm
by Eddbot
i tried thinking of ways to articulate my question with real words, but i only got the last half into words...so here it goes
I got one of these:
i need it to fit in a 3/8" chuck...any ideas?
Posted: Sat Apr 26, 2008 11:32 pm
by willarddaniels
cut off the end
EDIT: I have never seen an adapter for a standard chuck to fit your variable spade bit shank. Really, if you can't use it otherwise and it is not on loan from someone else, cut the end off.
Posted: Sun Apr 27, 2008 8:36 am
by Matheusilla
Yeah, just cut off the end. Just so people know, the square end on the drill shank fits in old hand drills called a "bit brace" style crank drill. You should easily be able to cut it with a hacksaw.
Posted: Sun Apr 27, 2008 12:36 pm
by rp181
yes, cut the end off, but also grind 3 or 6 flat sides, it holds better.
Posted: Sun Apr 27, 2008 2:08 pm
by Eddbot
well, i don't really want to chop it off, i'll look around some more, but it looks like i might have to cut it
Posted: Sun Apr 27, 2008 3:54 pm
by jimmy101
rp181 wrote:yes, cut the end off, but also grind 3 or 6 flat sides, it holds better.
Flats would be nice but be careful. If the flats aren't exactly right the bit will be off center. This type of bit will be
very unhappy if it isn't centered perfectly in the chuck.
Posted: Sun Apr 27, 2008 6:35 pm
by Eddbot
yeah, i'm not grinding any flats, too dangerous, plus the chuck on a drill press has a pretty tight grip so circular should be fine
Posted: Sun Apr 27, 2008 7:12 pm
by jrrdw
Why not get a 1/2" chuck? I've got one on my 3/8ths drill, it's a cheezy craftsman, works great.
Posted: Mon Apr 28, 2008 12:02 am
by Eddbot
would it work on a drill press? Link?
Posted: Mon Apr 28, 2008 12:22 am
by willarddaniels
jrrdw wrote:Why not get a 1/2" chuck? I've got one on my 3/8ths drill, it's a cheezy craftsman, works great.
Which do you have? A 1/2" or a 3/8"? Or did you put a 1/2" chuck on a drill motor designed for a 3/8"?
The 1/2" chuck won't make a difference with this bit, it still won't grab the shaft evenly, if you are suggesting using the larger chuck.
Posted: Mon Apr 28, 2008 8:09 am
by jrrdw
willarddaniels wrote:jrrdw wrote:Why not get a 1/2" chuck? I've got one on my 3/8ths drill, it's a cheezy craftsman, works great.
Which do you have? A 1/2" or a 3/8"? Or did you put a 1/2" chuck on a drill motor designed for a 3/8"?
The 1/2" chuck won't make a difference with this bit, it still won't grab the shaft evenly, if you are suggesting using the larger chuck.
I put a 1/2" chuck on a 3/8ths drill. Square shank, your right, it still wont grab it right because it's got 3 jaws not 4. Good catch Willard. I don't know if any one makes a 4 jaw chuck for a eletric drill.
