Hello everyone, I've encountered a strange problem during equipment debugging: the stepper motor (https://www.oyostepper.es) occasionally rotates in the opposite direction briefly before continuing to run normally.
The pulse and direction signals are differentially output, the wires are shielded, and the ground wire is connected. I've captured the direction signal with an oscilloscope and haven't seen any glitches.
Could it be that the driver's internal logic misinterprets the direction signal under certain conditions? Or is a delay needed between the pulse train timing and the direction signal switching?
Has anyone encountered this situation before? How did you troubleshoot it?
Stepper Motor Running in Reverse Direction
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 145219 Views
-
Last post by Zirek
-
- 1 Replies
- 27237 Views
-
Last post by karlsinner
-
- 1 Replies
- 17969 Views
-
Last post by willaimwhite
-
- 4 Replies
- 62248 Views
-
Last post by hedtame
-
- 23 Replies
- 8159 Views
-
Last post by SNDM
