Page 1 of 1
Barrel Sealing Valve (log)
Posted: Wed Apr 02, 2008 8:32 pm
by Counterstriker
Ok, So I am constructing a Barrel Sealing Valve and thought I will make a log and ask all my questions in this one topic. So far I am good with questions, But this is my piston design
Posted: Wed Apr 02, 2008 8:40 pm
by bigbob12345
my questions are
1.what is that rubber washer going to be sitting on top of?
2.not really a question but with a bolt that large it will weigh a lot
3.what are you going to be using for the bumper?
edit:one more question
1.5in pvc is not a very good fit inside 2in so are you going to wrap tape around it or what?
Posted: Wed Apr 02, 2008 8:47 pm
by pizlo
Be ready for some hard work, they tend to take a lot of tweaking, I'm still working on mine :p and not to be rude but I bet all of the questions you can come up with have been answered a few dosen times in the past few months.
Posted: Wed Apr 02, 2008 9:09 pm
by bigbob12345
lol
I finished my most recent piston valve in about ten minutes and it didnt take much tweaking.
Posted: Wed Apr 02, 2008 9:10 pm
by bluerussetboy
What is your question and why didn't you search???? Puhleeeze tell me you searched and there were no answers to your non existent question.
Posted: Wed Apr 02, 2008 9:11 pm
by bigbob12345
calm down its just a build log
Posted: Wed Apr 02, 2008 9:14 pm
by sjog
I got a nice piston from c19o a few months ago.
1 1/2" w/o-rings. It was tight in the 2" pipe so I honed the pipe till it slid easily. Made a good valve , copied his design . Worked great first time I set it up.
http://i179.photobucket.com/albums/w303 ... CT2004.jpg
http://i179.photobucket.com/albums/w303 ... CT2003.jpg
http://i179.photobucket.com/albums/w303 ... CT2002.jpg
Posted: Thu Apr 03, 2008 6:37 pm
by Counterstriker
bluerussetboy wrote:What is your question and why didn't you search???? Puhleeeze tell me you searched and there were no answers to your non existent question.
Dude Stfu
It's a build log moron..
