SpudFiles

As much as I hate taking other peoples ideas, I have a piston valve I need an air chamber design for, maybe someone has an awesome design that wouldnt mind passing down ill be using 2 inch pvc for an air chamber thanks guys


Jrrdw (this is that valve )

http://www.spudfiles.com/forums/pneumat ... se-f1.html

Try using that idle lump between your ears and bloody well LOOK for yourself.

If it was my cannon I would use a piece of 2" X 7" to a 2" to 3" bushing, a 3" coupler and a piece of 3" X 12" for the chamber. That will give you about 5"s of 2" for a forward hand hold and eliminate the need for a longer 2" chamber.

jrrdw wrote:If it was my cannon I would use a piece of 2" X 7" to a 2" to 3" bushing, a 3" coupler and a piece of 3" X 12" for the chamber. That will give you about 5"s of 2" for a forward hand hold and eliminate the need for a longer 2" chamber.

Sounds like an amazing idea

could you please send with a pic ecause im new and have great ideas but not if i dont know what your talking about and also im not always sure what you are talking about

dart guy wrote:could you please send with a pic ecause im new and have great ideas but not if i dont know what your talking about and also im not always sure what you are talking about

Pic of what??