Page 1 of 1
Valves
Posted: Wed Jan 13, 2021 3:02 pm
by ClaytonM223
Hi, I am Clayton from the Van Wert robotics team and I need help finding a valve that I can use on our FRC robot that we will use to shoot t-shirts at ball games. We intend to have a bank of 7 or so barrels that will shoot individually. I need to find valves that can allow the CO₂ into the barrel from the tank. They need to be as cheap as possible. Thanks for the help!
Re: Valves
Posted: Thu Jan 14, 2021 5:46 am
by farcticox1
Any pictures yet or is it still being designed.
Re: Valves
Posted: Thu Jan 14, 2021 7:04 am
by jackssmirkingrevenge
Welcome to the forum!
Are you regulating the CO2 or using it at full pressure?
If you want something off-the-shelf that is reasonably priced, a Quick Exhaust Valve is your best bet.
some eBay links:
https://www.ebay.com/itm/New-SMC-NAQ500 ... SwLq1f1SNp
https://www.ebay.com/itm/1pcs-Quick-Exh ... Sw-INa0ByX
You will need to bring the CO2 pressure to about 300-400 psi for safety reasons and the pressure should compensate for the low valve seat diameter compared to the t-shirt bore.
The challenge would be the exhaust valve to actuate the QEV. Solenoid Valves are expensive for higher pressures, you could consider using a
slide check valve hooked up to a servo, this would do double duty of firing the QEV as well as cutting off CO2 flow from the main tank.
Re: Valves
Posted: Thu Jan 14, 2021 8:35 am
by ClaytonM223
We are still designing the robot and we plan to regulate the CO₂ before it goes into a accumulator tank