First off, I think I put this in the right topic. Anyway, my third gun is in production, well, the planning stage. I wanted another pneumatic, resembeling a rifle and of course, low calibre barrel. I looked over several posted designs and peiced some together and wound up with this.
I took my time in the planing what goes where, but I did this in paint, too lazy to draw. It has no measurements (open for suggestions if you wanna throw), I also will add a PSI guage somewhere.
I feel the picture is pretty self explanitory, just wanting some input before I start going pipe crazy. Also, if you see something resembling a part of your gun and feel I copied you, I prolly did. Sorry, and if it bothers you that bad, well i'll leave it the way it is and say I changed it .
Once again, post comments and sorry if I put this in the wrong topic(don't think I did.)
SR-01
- Ballad_Black
- Specialist
- Posts: 159
- Joined: Sat Oct 15, 2005 10:38 am
- Attachments
-
- SR-01.PNG (12.8 KiB) Viewed 2643 times
- saladtossser
- Sergeant 3
- Posts: 1234
- Joined: Sat Mar 26, 2005 10:40 am
- Location: Toronto
- Contact:
awesome, what size is the barrel?
"whoa... I thought pimpmann was black..."-pyromanic13
- Ballad_Black
- Specialist
- Posts: 159
- Joined: Sat Oct 15, 2005 10:38 am
I was thinking of going with a 3/4 barrel, 1.5 or 2 inch compression chamber. Still have to find a sprinkler valve, looks like the net is the only place I can get one. None of the stores in my town carry them, I found this odd.
But anyway, the barrel I wanted small, for smaller projectiles, marbles, batteries, etc. I might add a breech or a poor mans breech, not too sure. I could always put a washer at the back of the barrel to hold the ammo in.
But anyway, the barrel I wanted small, for smaller projectiles, marbles, batteries, etc. I might add a breech or a poor mans breech, not too sure. I could always put a washer at the back of the barrel to hold the ammo in.