If, lets say, there was a pipe with an internal diameter of about 1 1/2'' filled with air and a continuous spark from a stungun was arcing across a gap in the centre.
If a large amount of propane in the form of gas started passing passed it, would the propane ignite?
Tricky question.
It depends on if there were enough air for the propane to burn in.)DEMON( wrote:If a large amount of propane in the form of gas started passing passed it, would the propane ignite?
A blowtorch works on a continuous stream of propane/butane, although it does need lots of air mixed in to get a really hot blue flame rather than a relatively cold yellow one.
Does that thing kinda look like a big cat to you?
-
rednecktatertosser
- Corporal
- Posts: 590
- Joined: Tue May 22, 2007 7:52 pm
Demon you crazy sob, I think I see where this is going...
It should work if, likr others have said, there is the right ammount of Fuel and oxygen mixed as it flows over the spark.
now, are you looking for closed combustion, or more of a flow of ignited gas?
It should work if, likr others have said, there is the right ammount of Fuel and oxygen mixed as it flows over the spark.
now, are you looking for closed combustion, or more of a flow of ignited gas?
"When you tell some body something, it depends on which part of these United States your standing in, as to how dumb you sound."
-Burt Reynolds as: Bo "Bandit" Darville
-Burt Reynolds as: Bo "Bandit" Darville
-
TurboSuper
- Corporal 5
- Posts: 986
- Joined: Thu Jun 16, 2005 1:44 pm
- Been thanked: 1 time
You really don't even need an arc, just a quick spark to get it going.
"If at first you dont succeed, then skydiving is not for you" - Darwin Awards
-
jimmy101
- Sergeant Major
- Posts: 3197
- Joined: Wed Mar 28, 2007 9:48 am
- Location: Greenwood, Indiana
- Has thanked: 5 times
- Been thanked: 15 times
- Contact:
Like others have said, as long as the mixture is correct it'll ignite. It may take a bit hotter spark though.
To keep it lit you have to get the mixture and the flow rate correct. For a stable flame the gas flow rate has to be the same as the flame propagation rate. At room temperature and pressure that's about 0.4m/s (16inch/sec). Through a 1.5" pipe that would be a heck of a lot of propane+air moving.
To keep it lit you have to get the mixture and the flow rate correct. For a stable flame the gas flow rate has to be the same as the flame propagation rate. At room temperature and pressure that's about 0.4m/s (16inch/sec). Through a 1.5" pipe that would be a heck of a lot of propane+air moving.
jimmy, about keeping the flame in the same place with the use of a gas flow just as fast as the flame propagation rate, do remember that turbulence might speed it up, and when DDT occurs there is no gas flow fast enough to hold it. 
-
jimmy101
- Sergeant Major
- Posts: 3197
- Joined: Wed Mar 28, 2007 9:48 am
- Location: Greenwood, Indiana
- Has thanked: 5 times
- Been thanked: 15 times
- Contact:
Even with turbulance you can get a stable flame, it's done all the time to study flame propagation rates.psycix wrote:jimmy, about keeping the flame in the same place with the use of a gas flow just as fast as the flame propagation rate, do remember that turbulence might speed it up, and when DDT occurs there is no gas flow fast enough to hold it.
As for DDT, a stable flame pretty much implies constant pressure, as in a bunsen burner or a Bernzomatic torch. Constant pressure means DDT is impossible.
Since the OP didn't mention why they wanted flowing fuel its kind of hard to know if is is a constant pressure setup or not. Combustion spudguns will ignite even when a chmaber fan is moving the gases past the spark gap at a pretty good speed. Indeed, they work better with the fan running.
umm...last time I checked, a yellow flame usually ranges from 500-1,000*C using propane gas as your fuel source.Ragnarok wrote:although it does need lots of air mixed in to get a really hot blue flame rather than a relatively cold yellow one.
"Cold"? I think NOT! lol
Forum Rules - follow them or else!
“Happiness is the meaning and the purpose of life, the whole aim and end of human existence”
“Happiness is the meaning and the purpose of life, the whole aim and end of human existence”
You're missing the point of the term "Relatively".STHORNE wrote:"Cold"? I think NOT! lol
A blue propane flame is between 1500 to 2000 degrees C. Relative to that, a yellow flame is indeed cool.
Does that thing kinda look like a big cat to you?
Fuel/air mixture is the key as has been stated. Jimmy's website has an excellent write-up on several aspects of fuel mixture and spud world tests in general. Here's one that you could start with, then another here.
