Page 1 of 1
1'' Piston Hybrid {WIP}
Posted: Sat Apr 07, 2012 3:16 am
by Crna Legija
This is just a update since posting
this, its getting there just need a few more fitting and a good pressure gauge for the meter, for the time being ill use a camera flash dumped in a car ignition coil for ignition but would like something a bit smaller later on.
Posted: Sat Apr 07, 2012 4:07 am
by wyz2285
Looking good, may I see your ignition set up?
Posted: Sat Apr 07, 2012 4:28 am
by Crna Legija
wyz2285 wrote:Looking good, may I see your ignition set up?
Its far from done but just a car ignition coil and im dumping a camera flash though it, makes big sparks iv got 5cm in open air my spark plug is just that i found some plugs that are very close fit to 1/8 npt bit lose but im sure they be fine. if you want some they are CE10EK
Posted: Thu Apr 19, 2012 2:48 am
by Crna Legija
Update: just about finished, bought
this pressure gauge, just wating for it to come then i can start tuning it.
I'm also looking for a smaller coil to replace the car one it massive.
edit: not that gauge this one
http://www.ebay.com.au/itm/251041238561 ... 500wt_1287
Posted: Wed Apr 25, 2012 1:10 am
by Crna Legija
My gauge came in I need to get a propane tank and then I can test it.