Hi. I am interested in making an airsoft/bb single shot rifle. I am using a modded blowgun connected to a barrel on one end, and a PVC chamber on the other. I was wondering how I should do the tubing connecting the blowgun to the chamber. Do I need to buy a set of blowgun fittings? Any help would be appreciated.
Thanks.
Single Shot Gun
-
PVC Arsenal 17
- Staff Sergeant 3
- Posts: 1762
- Joined: Mon Mar 27, 2006 4:18 pm
- Location: United States
Tubing? All you need is a couple barbed fittings that match the ID of the tube you plan on using.
-
Thursto
- Specialist 3
- Posts: 389
- Joined: Fri Mar 02, 2007 5:11 am
- Location: Australia, SA, Adeliade, Para Hills
And make sure when you buy barbs that they screw into your blowgun nicley, even use a bit of Plumbig tape, and then slide over one of those clips that when you screw wid a screw driver it tightens up, this will help seal the air.
-
experament-u2
- Specialist 4
- Posts: 469
- Joined: Tue Dec 26, 2006 11:18 pm
there called hose clamps and they work rely well
just a question would a gul like this work well for shooting cans with steel bbs or would it suck?
just a question would a gul like this work well for shooting cans with steel bbs or would it suck?
-
Flying_Salt
- Corporal 3
- Posts: 779
- Joined: Mon Oct 09, 2006 4:57 pm
- Location: Texas
experament, from what I've heard, blowguns can work pretty good for small bb guns, so it would probably be good for shooting cans.
sgort87 wrote: I hereby present Flying_Salt with The one and only <a href="http://www.geocities.com/sgort87/ghetto">Ghetto Award!</a>