Page 1 of 1
Finally! hammer valve time!
Posted: Fri Feb 01, 2008 3:28 pm
by Necrosis
I finally have the valve part of the hammer valve done!
The rest of the contraption will be posted in this thread when it is done too!
Posted: Fri Feb 01, 2008 5:02 pm
by pizlo
So this would have a spring pushing it, and would be held forward until you triggered it?
Posted: Fri Feb 01, 2008 5:51 pm
by ghostman01
not exactely i guessing hes going the same as me with my gun his whole barrel moves and hit this letting air out momentarely then closeing again from the spring and air pressure
Posted: Fri Feb 01, 2008 6:21 pm
by pizlo
okey-dokey
this is just to make the post long enough to post
Posted: Fri Feb 01, 2008 9:07 pm
by Gippeto
Looking good!
Is this your "condor" style valve? Keep up the good work!
Posted: Fri Feb 01, 2008 9:31 pm
by ghostman01
be good wunsh its finished
Posted: Sun Feb 03, 2008 4:49 am
by Necrosis
This will be a more traditional over/under style, as found in many Airguns.
And thanks for all the kind replies.
Posted: Sun Feb 03, 2008 5:38 am
by Antonio
Nice job! I wish I had machines to make this. Would be perfect to make a drozd valve like this!!