Mechanical BBMG.
Posted: Thu Nov 09, 2006 5:39 am
Well i thought of this about a week ago and have decided to post my ideas here and see if anyone can see any problems with it or any way to impove the design.
So here goes.
There is a 1/4 ball valve,which has the little handle for open/close removed so the 'ball' can do full revolutions.
Connected to this ball valve is a quick disconnect and that is connected to a continuous air supply.
The turning point if the ball valve is then connected to some type of motor such as a battery drill.This allows the 'ball' to do many full rotations quite fast but with a small pause time between the rotations.This could be used on a portable gun,with a chamber as not as much air would need to be used.
Any type barrel then could be connected,prefribly BBs or small shot.
A type of feeder for the ammo would be needed maybe gravity fed or spring fed,i plan to build this in the following days and have it posted.
So here goes.
There is a 1/4 ball valve,which has the little handle for open/close removed so the 'ball' can do full revolutions.
Connected to this ball valve is a quick disconnect and that is connected to a continuous air supply.
The turning point if the ball valve is then connected to some type of motor such as a battery drill.This allows the 'ball' to do many full rotations quite fast but with a small pause time between the rotations.This could be used on a portable gun,with a chamber as not as much air would need to be used.
Any type barrel then could be connected,prefribly BBs or small shot.
A type of feeder for the ammo would be needed maybe gravity fed or spring fed,i plan to build this in the following days and have it posted.