A mini pneumatic?
Posted: Thu Jan 25, 2007 6:57 pm
That would be.. weird...
Anyone has an idea what I could use as a valve?
Anyone has an idea what I could use as a valve?
Page 1 of 3
Posted: Thu Jan 25, 2007 7:00 pm
Killa used a micro valve on a tiny miny of his.
Posted: Thu Jan 25, 2007 7:13 pm
A ghetto burst disk? It's been done.
Posted: Thu Jan 25, 2007 7:24 pm
Why couldn't you use a blowgun?
Posted: Thu Jan 25, 2007 8:19 pm
I'll get around to making a 1" chamber coaxial sometime. Airsoft barrel most likely, with a diaphragm. Maybe, 4-5" long.
Posted: Thu Jan 25, 2007 8:20 pm
Where can you get an airsoft barrel...
And for the valve.. I think I've spotted what would work (goes on the internet to search for a picture)
And for the valve.. I think I've spotted what would work (goes on the internet to search for a picture)
Posted: Thu Jan 25, 2007 8:25 pm
Something like that...
but straight..
but straight..
Posted: Thu Jan 25, 2007 8:28 pm
Thats called a ball valve...
Posted: Thu Jan 25, 2007 8:30 pm
Oh, I thought a ball valve were only the big round one.
Posted: Thu Jan 25, 2007 9:43 pm
This may be too short for what you have plans for, but the tube from the pen model called Scripto stick pen medium fits airsoft pellets perfectly, it's about five inches long. I made a mini with one earlier today.
Posted: Fri Jan 26, 2007 12:03 am
Mini pneumatics are easy.
Use steel pipe nipples, ball valves, and a male disconnect.
Use steel pipe nipples, ball valves, and a male disconnect.
Posted: Fri Jan 26, 2007 1:46 pm
I can get 9/32" brakeline, which is a fit within half a millimeter of an airsoft BB's OD.
Posted: Fri Jan 26, 2007 5:00 pm
Today I am going to make a mini pneumatic with a blowgun as the valve, think that'l work?
Posted: Fri Jan 26, 2007 6:52 pm
Hey.. I didnt think about that...LGM wrote:Why couldn't you use a blowgun?
Posted: Fri Jan 26, 2007 7:19 pm
Blowgun valves are fine, but the barrel needs to have a TINY diameter.