3/8" QEV

[sinper2006]

i'm just wondering where i can find a 3/8" QEV in australia i don't really wanna buy off the internet

[Hotwired]

The thing is, QEV's are specialist pneumatic components, so unless you actually have a pneumatics place in your area they tend to be ordered by mail or web.

All the places I know that sell QEV's in the UK have a few massive warehouse locations and ship out all over from there.

[sinper2006]

ok so if i try a shop with nail guns air compressors and the fittings and stuff for them do u think they could be there?

[Hotwired]

No. They aren't meant for general public use with tools and so on.

They're for pneumatic cylinders which means industrial use. It needs to be a specialist pneumatics place or a we-sell-everything place like mcmaster.

[sinper2006]

ok well i'll have fun trying to find 1 then lol. i gess i'll post tomorrow when more aussies on they might no a shop

[MrCrowley]

It'll set you back more then it's worth, but <A HREF="http://www.rsaustralia.com/cgi-bin/bv/r ... auie">here you go.</a>

[Isomer]

This probably doesn't help you much but I'll give it a go; If you have Granger (sp?) in the area then they carry them. They are basically just like McMaster. Granger can also be nicer because they have more warehouses (that you can actually walk up to and buy the stuff) than McMaster. They're just super awesome cause theres one right next to my house.

[sinper2006]

i don't think Granger has any warehouses in aus

[MrCrowley]

See my link. It is what you wanted, where you wanted (Aus).

[sinper2006]

hmm they cost a far bit don't they o well i might have save me cashor i'll make a piston valve can u make a piston valve the same od as your barrel?

[MrCrowley]

Told ya they weren't cheap.

If you're that way in mind, yes, but it would not be good for Mr. Performance.

Why can't you go bigger? Pipe in Aussie is cheaper then NZ so be grateful

[sinper2006]

i think your money is worth more than ours but i dunno how it works. ok so i should make it bout 15mm to 20mm

[MrCrowley]

Yeah but you guys make more, unfortunately.

What's your barrel size? Try to at least go a size up then your barrel with the piston housing(tee).

e.g 15mm barrel, 20mm tee housing. 20mm barrel, 25mm tee housing.

That's usually a good bet.

[sinper2006]

awsum it goin to be cheaper barrel od is 10mm and id is 8mm so 15mm brass tee