pnumatic preformance

[)DEMON(]

ok,so if your barrel ,valve and chamber were all linked together with silicon pipe about 9mm thick on the inside would it affect the preformance of the gun in any way?

[Benny]

can you give us a link to this sillicone pipe? it shouldent do any thing to the prefvormance but it will have lower volume. edit, its pneumatic. not pnumatic.

[boilingleadbath]

By "silicon pipe" I assume you mean silicon rubber tubing.
This is typicaly a translucent, soft rubber, and slightly tacky.

If correct... that stuff isn't really made to take much pressure (although it's probably fine for our use - just don't blame me if it pops), and with an inner diameter of only 9mm, it'll affect preformance a fair amount.
You can model it with the GGDT by limmiting valve flow to a Cv of ~2.16

[)DEMON(]

What other ways can you link your system,without using pvc parts.I would think that using thicker tube will mean better preformance ,right?

How can i improve my chamber?

[Benny]

id change the valve, the watergun valve is probadly the worst at releasing the pressure.

[)DEMON(]

no ,that valve is very good,it releases air quickly

[Benny]

can you show a closeup of th valve, also is it like a piston/diafram valve or what.

[)DEMON(]

valve