Slide check?

[Dave_424]

Just a quick question, would a 1/8" slide check rated to 16 BAR take unregged co2?

Would I be better off getting one for paintball, would it have enough flow when exhausting to pilot a 1/8" QEV?

Dave

[trae08]

16 bar is around 230 psi

"unregged" co2 is depending on the temp around 700-900

you should be able to find one for what you need on mcmaster.

[john bunsenburner]

a lttle thread hj jack: How much pressure an an average blowgun hold, at what pressure can you not open it anymore?

[Dave_424]

I can easily open it at 600 psi

Dont know about higher pressures

Dave

[grumpy]

Just a quick question, would a 1/8" slide check rated to 16 BAR take unregged co2?

Would I be better off getting one for paintball, would it have enough flow when exhausting to pilot a 1/8" QEV?

Dave

if it's only rated for 16 bar, then no it would not take unregged co2 as unregged co2 is around 850 psi.

yes a paintball one would better cause it will handle the pressure, it would have same flow rate as the other one.

where did you find a QEV that will take 850 psi ?

[Dave_424]

regular QEV's (The cylindrical) ones have been tested in 1/2" regularly up to 850 psi

a 1/4" or 1/8" one would withstand more

Dave

[maggotman]

most things have a working pressure with a big safty factor

dave i have taken a 15mm check valve to 600 psi what is its use in your gun