best configuring a BBMG

[JDP12]

Hey all-

I've been working on my unreg BBMG and my biggest problem has been getting my stupid valve to configure.

In the picture the hexagonal part is the outlet. The tee houses the elbow( This is based on BTB's design. )

I thought about putting it forward of the tee like in the one picture, and that would work, but would take up a fair bit of space, especially cuz i'd have to use brakeline to get the air to the tee.

Then I thought of the second configuration i have- placing it next to the tee and bending some brakeline creatively to get it down to the tee.

I think this would work best- especially because I want this to resemble the PP-2000- http://world.guns.ru/smg/smg61-e.htm

I was going to have a 90 street elbow coming out the back of tee going down through the grip as a mag well. Then the tee would be fairly good positioned over the trigger, allowing for the pin to be reached easily with the trigger.

Then the inlet of the valve would go to the front of the gun, drop down into the front grip for a 12 gram.

What do you guys think? I like the side by side configuration the best, seems the smallest.

What do you guys think? Any other way to get it into as small of a package as possible? This may not make awhole lot of sense...sorry if its a little confusing.

<img src="http://i157.photobucket.com/albums/t79/ ... 1242787385">

<img src="http://i157.photobucket.com/albums/t79/ ... 1242787425">

<img src="http://i157.photobucket.com/albums/t79/ ... 1242787450">