Digging up an old thread - How do you fill this gun ? Couldnt see a valve anywere - Do you pull the tank off ?
Thanks
Accuracy Issues?
I got the same problem. i've seen on your later post that you somehow managed to resolve it :At higher pressures the slide valves become less efficient and... ergonomic? I lose air when I pull it as a trigger, and I lose air when I push it forward to feed, higher pressure = more air lost. Also, since it gets harder to pull, it throws off my aim because I end up yanking the gun a bit
what did you change ?put back the slide valve and its fantastic. Operating at 800 PSI.
I have tasted the maggots in the mind of the universe, but I was not offended.For I knew I had to rise above it all, Or drown in my own ***
-
jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
A little complex but you could consider spring-loading the slide valve, so that pulling the trigger releases it...
hectmarr wrote:You have to make many weapons, because this field is long and short life