3D printed golf ball dart tails (image attached)
-
Moonbogg
- Staff Sergeant 3
- Posts: 1737
- Joined: Mon Oct 13, 2008 10:20 pm
- Location: SoCal
- Has thanked: 166 times
- Been thanked: 102 times
Drill hole in golf ball and attach with self tapping screw through the dart tube. Think they will work good? I didn't mess with center of gravity or anything. Could be fairly cheap and easy to install. Might be awesome.
- Attachments
-
-
D_Hall
- Staff Sergeant 5
- Posts: 1945
- Joined: Thu Feb 07, 2008 7:37 pm
- Location: SoCal
- Has thanked: 11 times
- Been thanked: 44 times
It will probably work, yes. But I think it's also a lot tougher than required. Put it this way... I've had decent luck with nothing more than a 2" deck screw. Drill a small hole into the ball. Screw the deck screw in. Done. Doesn't look nearly as cool, but it works.