3'' slider

[flamerz14]

What size of pipe will slide nicely over a 3" pipe? I was thinking about using it as a sliding loader in my pneumatic pistol.. and what can I use to hold the slider in place so it doesn't blow off when I fire?

[Velocity]

3" couplings bored out fit perfectly over 3" pipe

[singularity]

about the slide loader on the pistol, i don't knowhow big your barrel is but on my 1/2 paint ball barrel i used a a 1/2 coupling that i hollowed out a little bit with a dremel. its held in place with a spring and prevented from moving to far with a hollowed out 1/2 tee

heres a pic

<img src="http://i78.photobucket.com/albums/j85/i ... CN1627.jpg">

[flamerz14]

singularity my barrel's 3''... so whats that little metal thingy that holds the spring? and thanks though..

[joannaardway]

flamerz14 - the same technique applies at 1/2" as 3". Just use a bored out coupling - preferably with O-rings if you can.

[singularity]

the spring is just a weak peace of wire i coiled up, i left a little extra wire at th end to hold it in place. i made a a small hole and stuck the end of the spring of the spring in the hole, it holds it pretty well

[flamerz14]

ok... thanks guys 4 all your help! be on my way 2 make me pistol now..