how do you mod a sprinkler vavle that looks like this
http://ace.imageg.net/graphics/product_ ... 189reg.jpg
sprinkler valve
-
singularity
- Corporal 5
- Posts: 982
- Joined: Mon Jun 26, 2006 10:53 pm
- Location: someplace
- Contact:
pretty much the same as any other. i dont know the internals specifically but i bet you could drill a hole right in the center where the small black nob thing is. then tap it for 1/4 threads and attach a blowgun valve.
if you could remove the top and take a picture for me i could bee sure.
if there is some sort of clearance issue with drilling a hole in the center it would be fine to drill a hole off to one of the sides so long as it doesn't interfere with the movement of the diaphragm.
you can either leave the solenoid in place or take it out and fill its hole with epoxy, it doesn't matter.
if you could remove the top and take a picture for me i could bee sure.
if there is some sort of clearance issue with drilling a hole in the center it would be fine to drill a hole off to one of the sides so long as it doesn't interfere with the movement of the diaphragm.
you can either leave the solenoid in place or take it out and fill its hole with epoxy, it doesn't matter.
be sure to check out my <a href="http://www.spudfiles.com/forums/ak-styl ... 9.html">AK Styled Vortex Gun</a> and my <a href="http://www.spudfiles.com/forums/at-4-t9627.html">AT-4 Rocket</a>
upcoming projects... finalized clip fed BBMG and ball point pen sniper
upcoming projects... finalized clip fed BBMG and ball point pen sniper
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
