Page 2 of 2
Posted: Sat Aug 25, 2007 10:15 pm
by mopherman
Mr.Russ wrote:
THIS GUN IS PERFECT!
I wouldn't say perfect, but very nice. you should try and make a faster opening valve. the performance boost will surprise you
Posted: Sat Aug 25, 2007 11:30 pm
by Mr.Russ
it is perfect, for me anyway.
I dont want a faster openiung valve. Everyone suggest sprinklers, but i think theyre too bulky. The pistol grip makes it comfier, and i get about 4 powerful shots out of a tank. it drops 20psi every shot.
Posted: Sat Aug 25, 2007 11:58 pm
by MrCrowley
Mr.Russ, instead of clogging the blow gun top with hot glue, I found another solution.
I have the same blow gun and what I did was got rid of the guage(it's sh|t, they break fast and are flimsy) and cut the brass fitting of from the base of it.
It has a hole in the top of it, so find a screw that's similar size, thread a hole for it in the brass and then thread the screw in.
Once threaded, cut the top of the screw off and sand it down smooth, then screw the brass fittings into the hole where the guage was and cut the rest that sticks out, then sand it so its nice and smooth.
And your done, only takes like 5 minutes.
Posted: Sun Aug 26, 2007 1:01 am
by Mr.Russ
hm.
Ill leave this gauge on atm, i have another one spare.. might get around to doing this one day if i'm bored.
anyone have ideas about making a kind of accurate scope?