Posted: Wed Sep 19, 2007 3:43 pm
Quick question to you, Williamfeldman: Does your modded CP-100 honk at all?
It does work, Will. I recently tried and tested it and it holds the charged pressure too.williamfeldmann wrote:I actually believe it might be possible with the Rianbird to enlarge the holes in the solenoid system for increased flow and faster activation. I have to make a run through Menards tonight so I'll grab another valve and check it out. The solenoid on the Rainbird is huge in comparison to the Orbit, and the base/sealing face is basically the whole face at the bottom of the threads in the picture from my earlier post.
What I did was I used a tiny dremel pointed grinder bit to enlarge the pilot "exhaust" hole (the hole that the solenoid seats directly above). The reason I used the pointy bit was so that the enlargening of the hole would remain dead center -- it works much like a step drill bit. A normal drill bit could easily slide around during drilling, resulting in a misalignment with the solenoid sealing ring.
I had to be very careful with the pilot exhause drilling.
Will, I think that you may be confused, mixing up which port hole is the in let and outlet.My only question is whether or not the inlet port to the solenoid could be enlarged.
The hole that enters the solenoid's threaded chamber is the one that the solenoid does not rest above. And the hole that the solenoid's ring seals is the pilot outlet hole -- this is the tougher one to deal with, as being precise is a must.
The inlet port that leads air into the solenoid's isolated, threaded chamber
is actually the easy part o deal with. You don't really have to be precise when enlargening that hole, since nothing seats directly on top of it.
