SpudFiles

mtronic wrote: I dont know what state your from man but in NSW youd get f&cked up for growing, its a big fine and possible jail time. Its considered a saleable amount if over, i think 5 grms and thats a decient fine in itself.

Trust me I've read the laws, I wouldn't risk it if there was a possibility of jail time. The only way you can go to jail is if you are growing a lot INDOORS, they don't like that. The only dodgy thing is as soon as you pick the buds off your plants outdoors it goes from a cultivating cannabis (100 buck fine) to "possession with intent to sell" which is a lot worse. I'm growing a lot in the bush this year away from my house anyway so no risk at all really.

mtronic wrote: Where as with a spuddy if you weren't being dangerous with it the cops would have a laugh, take it from you and use it back at the station.

Not since I've been caught with 2 of them before, and since I tend to carry them round in my boot to show off or cast my fishing lines real far.

A question, Do you smoke the weed?

Smokers are jokers.

Redcoat wrote:A question, Do you smoke the weed?

Smokers are jokers.

I've been known to on occasions I do it mainly because its a challenging, nice smelling plant and I seem to be very popular around harvest time.

all is good in moderation

^Wise words;)

SO true JSR.

My evil plan is coming to fruition, muhahahaha

I had to get a ball valve tho coz bunnings is always outta stock of anything I want

You already broke the first rule of growing marijuana! Tell NO ONE!

Regardless, I would like to keep this forum PG-13 so please take any drug related discussions to Theopia .

F%ck bunnings mate, those corporate wh%res dont need your money find yourself a good local supplier

Still have to paint it and fit the trigger but It's almost done. I have to wait 24hrs now for the glue to dry. Fingers crossed this thing bloody works its cost me an arm and a leg, since I changed plans half way through and had to buy a few different parts.

So did you pneumaticly mod the sprinkler valve?If so make the hose for the sprinkler gun as small as possible or remove it completely.

nice looking gun but it needs a paint job (i can see two differnt colored stains on it!) also is your barrel cell core or just dwv?

rna_duelers wrote:So did you pneumaticly mod the sprinkler valve?If so make the hose for the sprinkler gun as small as possible or remove it completely.

Yeh I had a go at modding the valve, I haven't cut the hose to length or installed the trigger yet, tomorrow afternoon I will test it at 30PSI, will this be enough to make the valve open properly? Is 24hrs enough to wait for the glue to dry, to test it at 30PSI?

The suspense is killing me

Watto

thespeedycicada wrote:nice looking gun but it needs a paint job (i can see two differnt colored stains on it!) also is your barrel cell core or just dwv?

The reason the pipe welding is so dodgy is because I had to do it quick so my old lady wouldn't see it and I knew all along I was going to paint it. The 2 different colours are primer and glue (the primer removes oil and makes the seal better)

The barrel and all the parts are class 18 which is close to sch80 (rated to over 400PSI I think) except the 25mm pipe (class 12) which is only used inside the fittings.

Watto

FFAAARRRKKK I just tested it at like 30PSI and it WORKS!! couldn't hear any leaks or anything. I cant wait till tomorrow when I'll go to 60 PSI.