Posted: Sat Oct 20, 2007 6:02 am
Ok, I'll go swap the 1/4in for a 1/2 tomorrow.MrCrowley wrote:I doubt it will be much, I usually fiddle around with pilot volume measurements on GGDT and an increase of 100cm^3 gives no change in velocity most of the time for my SGA gun(depending on cannon).watto wrote:I got a 1/4inch ball valve, like one person recommended, I can always upgrade to a bigger one in the future though. The gun is working now but lacks power, but I think filling up the hollow plug should help a lot.
I had a 3/8" ball valve on it once, which has a QC on the end, I could only get about 200m with a golfball, now I get 400 with a 1/2" ball valve, which is now upgraded to a 1" sprinkler.
I strongly recommend a 1/2" ball valve, it'd do a lot more then filling the plug, and it will save air, which saves pressure and gives more power.
