Posted: Thu Jan 17, 2008 4:48 am
2 or 3 are enough for the back one, it's the area that seals against the barrel that needs to be supported the most.
Page 2 of 2
Posted: Thu Jan 17, 2008 4:52 am
arr ok i'm looking for that thing you use to draw circles on stuff i swear i can never find wat i need when i wont to use it lol
Posted: Thu Jan 17, 2008 5:06 am
if i have got a 10 mm outta diameter wat size should i make the rubber 14mm?
Posted: Thu Jan 17, 2008 5:49 am
would this work. the little white thing under screw is the diameter of the inside of my barrel
Posted: Thu Jan 17, 2008 7:45 am
Hmmm ok that should work fine I think.
But did it need a triple post within one hour?
Use edit instead
But did it need a triple post within one hour?
Use edit instead
Posted: Thu Jan 17, 2008 7:48 am
i'm sorry lol i was making it as i was posting i sortta tested it buy holdin it on one end of barrel and blowing on other it didn't leak so now all i gotta do is go down to the hardware tomorrow and get a few bits
Posted: Tue Jan 22, 2008 8:29 am
GO FORD!!
im diggin the stock mate lol, nice recycling.
im diggin the stock mate lol, nice recycling.