Posted: Sat Jun 07, 2008 5:47 am
its rated for that high (philmac anyway dunno bout others) but i wouldnt take it that high.
Page 2 of 2
Posted: Sat Jun 07, 2008 5:49 am
Yeah I reckon 300psi would be good. With the low volume of my pump, it would take a bit of pumping. The only problem I have is the actuating valve.. A sprinker valve would pop at pressures over 200.... hmmmm...
Posted: Sat Jun 07, 2008 6:04 am
pn20 metal BVMitchza89 wrote:Yeah I reckon 300psi would be good. With the low volume of my pump, it would take a bit of pumping. The only problem I have is the actuating valve.. A sprinker valve would pop at pressures over 200.... hmmmm...
Posted: Sat Jun 07, 2008 6:07 am
My thoughts exactly. A 1'' BV with a 3/4'' long bend handle and a custom trigger, like the setup on my whammy guns 
.Hmm I might get myself a meter of 3/4'' aluminium tube as the barrel... I don't trust that 300psi spike in pressure that's gonna be running through the pressure pipe. Plus if it's polished, it'll look so so good
Posted: Sat Jun 07, 2008 12:21 pm
yea alum is nice aye, i got an old fire eq and with it was a 40cm long alum 15mm pipe with one end threaded i was like shotgun timeMitchza89 wrote:
Hmm I might get myself a meter of 3/4'' aluminium tube as the barrel... I don't trust that 300psi spike in pressure that's gonna be running through the pressure pipe. Plus if it's polished, it'll look so so good
Posted: Sat Jun 07, 2008 7:35 pm
That's gonna be a ripper:D. Whens the due date? hahaha
Posted: Sun Jun 08, 2008 1:44 am
hwenever i can find a cheap 20mm QEVMitchza89 wrote:That's gonna be a ripper:D. Whens the due date? hahaha
Posted: Sun Jun 08, 2008 9:55 am
Haha good luck mate. I've tried and failed many times .
.Posted: Sun Jun 08, 2008 10:56 am
well i found a 10$ 3/8" one so time will tellMitchza89 wrote:Haha good luck mate. I've tried and failed many times
Posted: Mon Jun 09, 2008 6:05 am
Hmm this topic should be closed down considering I've got the new one up....Hmm...