Posted: Sun Oct 09, 2005 2:42 am
what did u use for the muzzle break 
Page 2 of 3
Posted: Sat Nov 12, 2005 11:56 pm
wicked gun doesant the ammo fall out.
Posted: Sun Nov 13, 2005 1:52 am
Where did you get that barrel?
Posted: Wed Dec 14, 2005 11:06 pm
i think he got the barrel from an airsoft gun that he had
Posted: Thu Dec 15, 2005 5:50 pm
i was at my friends house and i got his airsoft barrel from hus broken gun..... i was usin it as a blowgun and shootin targets. i also got several RIS rails.
Posted: Fri Dec 16, 2005 10:50 pm
@ BLB and Tweak: yer, AC sprinkler valves can run off batteries, mine is rated 24V AC but i run it off 18V DC. the only problem is i wrecked the momentary switch so i raplaced it with a normal switch so have to remember to turn it off manually after every shot, big risk if i forget lol cos the batteries heat up and can explode lol.
yer, its a sweet gun i might have to make 1 i i get time and money lol.
couple of q's.
1. how long does it take to pump up? i assume not long...
2. any ideas where i can get a barrel like that in australia?
thx
yer, its a sweet gun i might have to make 1 i i get time and money lol.
couple of q's.
1. how long does it take to pump up? i assume not long...
2. any ideas where i can get a barrel like that in australia?
thx
Posted: Fri Dec 30, 2005 7:20 pm
i think an AC solenoid will run on DC it is just an electromagnet anyways
Posted: Sat Feb 25, 2006 11:57 pm
just how silent is the crow killer? and what type of sprinkler valve, release did u use on this gun? over all its a cool design
Posted: Sat Feb 25, 2006 11:59 pm
looks like some type of rainbird valve, i would have modded it, this ones still electronically actuated
Posted: Thu Mar 30, 2006 9:13 am
you know, if you used some copper piping and as short of an amount as you could get, that gun would fire much harder
Posted: Thu Mar 30, 2006 10:12 am
Who are you talking to Daemon???
This gun was posted in the stone age!!
This gun was posted in the stone age!!
Posted: Thu May 04, 2006 9:47 pm
how much psi can those valves handle. Well what's the greatest that you have seen anyways? (by you I mean whoever reads this i know this is an old thread)
Posted: Thu May 04, 2006 9:54 pm
150 psi......................................................................................
Posted: Thu May 04, 2006 10:23 pm
i thought 125 psi
Posted: Sun May 14, 2006 4:42 am
attatching a blow gun will work but it wont work as fast as the solinoid valve and blow guns cost around $12 and solinoid valves cost $15 so yeah make up your own mind but solinoid valves are the way to go 