SpudFiles

damage pics at 40~50 ish psi








i made the hole in the steel with a small center punch and some tape
and the hole in the 45mm worktop was done with a 22mm socket without the hole blocked

and my homemade compressor




its a 1/4hp motor 240 volt
it will pump up to 170 it will get to 200 but struggles when i tested the gun i pumped it up to 200 and did the last bit with one of them shitty pumps you can plug into a car

Nothing like home made If it's your finished cannon I can move this thread to the Show Case Section for you. That's where the completed cannons go. Nice work!

Edit: Wow get some compressor oil in the compressor! Your going to loose that rod bearing due to over heating and lack of lubrication.

its not finished yet thanks anyway

i need to block of hole in the compressor before a put oil in it as it sprays every wear its not many rpm and barley gets warm anyway