SpudFiles

Yeah it is fine, and the endcap socket will need an ID (inside diameter) of 75mm too. Your cap will probably have a thread of 3"?

John Bunsesnburner - absolutely. If the stuff you need isn't available in switzerland, then I see no reason not to email and ask! I imagine that hendersons would be more than happy to sort something out for you, but I can't imagine the postage would be cheap :O

I wasnt being specific, i asked overall(seeign i dont like PVC) but you answered my questiong perfectly thank you Biopyro

littlebro05 wrote:Just while you on epoxy... is epoxy casting and epoxy resin the same or different o.O cause epoxy in Australia is like super expensive it's like 5bucks for 8mL or 13bucks for 35ml... and halve them for the resin and epoxy ... I forget what their called

Have a look here, 500 grams for 20 bucks

Ok I have another quick question. The spigot reducers at hendersons are marked like this:

Spigot/Socket x socket
75/63 x 40mm

Would the above work for 40mm to 75mm pipe? I assume I could use a 75mm coupling to joing the spigot and 75mm pipe then just slot the 40mm pipe in the other socket end?

I would use TRS but their prices are more expensive and postage is a tenner!

Yeah, that's right.
Postage is more expensive on TRS but I thought general prices were a little cheaper?
Still I have sent you a PM

Sorry Biopyro but I bought the parts before checking your PM. Havnt checked here in a while.

My Kiowa order should be shipping tomorrow and my Hendersons order shipped today.

I know Kiowa is next day delivery, what method does Hendersons use to ship their pipe fittings?

No problem, I won't be working on that project for a while anyway
In my experience they have always been super quick, usually next day or the day after, so it should be with you tommorow or wednesday.