Page 2 of 2
Posted: Mon Jun 29, 2009 10:36 am
by maggotman
the onlay problem with doing it to a fridg compressor is the orignal motor cant cope with the input pressure, and usaly stalls and its not realy safe.
Posted: Tue Jun 30, 2009 2:55 pm
by psycix
I opened one up (didnt I post pictures of that?) and the reed valve was in the flat plate on top of the cylinder. The flat piston head nearly touches the top plate within like a tenth of a mm.
Dead space is minimal.
Posted: Tue Jun 30, 2009 7:18 pm
by Technician1002
psycix wrote:I opened one up (didn't I post pictures of that?) and the reed valve was in the flat plate on top of the cylinder. The flat piston head nearly touches the top plate within like a tenth of a mm.
Dead space is minimal.
How thick is the flat plate and the volume of the space in the hole? What is the dead space of the valve?
Spell check works.
Posted: Wed Jul 01, 2009 5:16 am
by psycix
Posted: Thu Jul 02, 2009 8:11 am
by maggotman
when mine stoped at 1800psi its was becuse of that paper gasket failing if i could titen down the bolts it probaly could have give more
