SpudFiles

I really dont know what the fuss is about. Its a decent question, and honestly, the forum search sucks

Thank you. Now we can all rest in peace.

rp181 wrote:I really dont know what the fuss is about. Its a decent question, and honestly, the forum search sucks

Yeah...if you don't know how to use it

I actually find it pretty decent, if you're looking for piston valves specifically in copper cannons, search "piston copper" and select "search for all terms (alternatively you can type "piston AND copper", then search in the Pneumatic Cannon Showcase. 148 results, pretty decent, we have heaps of copper cannons on the forum.

Perhaps you're searching for coaxial pistons, than you search "piston AND coaxial" or "piston AND co-axial" or some other variations.

It's pretty simple really and I think this question was pretty simple and a bit like asking how long is a piece of string. He gave us pretty much zero information.

But you could less time by just helping out. Insults and put-downs... not necessary.


Dead thread move on.

MrCrowley wrote:Yeah...if you don't know how to use it

There is NO EXCUSE for that now

spudkpi wrote:But you could less time by just helping out. Insults and put-downs... not necessary.


Dead thread move on.

Look at my first reply to you, I helped you out and I didn't insult you. If you're a little lazy, that's your problem. If we spent time helping out every new person when they can't be bothered helping themselves out, we wouldn't find time for anything else.

Seriously all you need to do is search, just a little searching fixes everything. We don't want to hear "how do I make a high pressure capable piston?" we want to hear "I looked at these designs and cannons, do you think XXX would make a good high pressure piston?", the difference between those two questions is a small bit of research.

dead thread. Ill show you the cannon when i'm done.