Page 2 of 2
Posted: Thu May 06, 2010 10:42 pm
by nosnik
ok guys! i got the gun, but now i do have some doubts about converting it as the plastic is rather fragile and seems breakable (the gun was like a total waste of money
cost me 8 bucks sigh. ) if u guys still want me to carry on with this project then i will otherwise i might try my hands on a hammer valve air gun
Posted: Thu May 06, 2010 11:48 pm
by Patto
if anything you could strip the internals and use it as a nice stock/cover
Posted: Thu May 06, 2010 11:51 pm
by jackssmirkingrevenge
show us the bits
Posted: Fri May 07, 2010 12:17 am
by nosnik
will do, but i have to say the plastic is ... very weak and prolly break easily.
(i used to own a nice wooden lever action toy rifle made from real wood and metal buit yeah.. my mom happened :'( )
Posted: Fri May 07, 2010 12:36 am
by kydavies
i thought i warned you that those guns were made in china (poorly build and covered in lead based paint) did i not?
Posted: Fri May 07, 2010 12:39 am
by nosnik
Posted: Fri May 07, 2010 5:31 am
by Demon
I also did buy this model of toy airgun ...
But it was not to mod it, to install a laser tag system in it but it was so small and weak that it broke when i opened it ...
You can could get enough power to pierce a paper sheet at 5 meter with a proper barrel and .12 .
I ended up modding it and it hurts pretty bad when you cut the dart in half, leaving only the end wich is in the barrel .
Posted: Sat May 15, 2010 1:46 am
by nosnik
sorry guys im really busy with exams and stuff i hope to take it apart by next week or so
