16.4 Ounce Containers for a Combustion Cannon

[kjjohn]

The fan survives the combustion because it is very quick. Although the combustion produces a few thousand degrees of heat, it only does so for a small fraction of a second, so the fan can survive it. The only time a fan won't survive is in high-power hybrids.

I would not run your ignitor/chamber fan off of a car battery. First of all, you can achieve the same thing in a much more portable package with something like an RC car rechargeable NiMH or Li-poly battery, and if that's too expensive, you can always go with a BBQ igniter.

Secondly, yes, a car battery could drive an ignition coil circuit well, but I wouldn't risk it with a little CPU fan. I'm no electronics expert, but I'd wager that the amperage a car battery puts out would be enough to toast your fan after a few minutes.

[lbfergus]

Can the tank be inverted or does it have to be stored 'right side up'.

[ramses]

Do not use the tank upside-down; the liquid propane will come out, freeze up your regulator, and cause problems.

I'm not sure about storage requirements, but I store mine right-side-up.

[Technician1002]

Storing them right side up is correct. That way the relief valve can vent vapor and lower the pressure to prevent an explosion if overheated. Inverted, it would vent liquid which would not appreciably lower the pressure and cause a fire hazard.

[SpudBlaster15]

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Cras nec placerat erat. Vivamus dapibus egestas nunc, at eleifend neque. Suspendisse potenti. Sed dictum lacus eu nisl pretium vehicula. Ut faucibus hendrerit nisi. Integer ultricies orci eu ultrices malesuada. Fusce id mauris risus. Suspendisse finibus ligula et nisl rutrum efficitur. Vestibulum posuere erat pellentesque ornare venenatis. Integer commodo fermentum tortor in pharetra. Proin scelerisque consectetur posuere. Vestibulum molestie augue ac nibh feugiat scelerisque. Sed aliquet a nunc in mattis.

[lbfergus]

Thanks for all of the help everyone!

My last (hopefully) question for this build, can I build a stand for this thing out of PVC? Or is the recoil too much for it to hold?

I plan on an overall length of about 8-10 feet.

[kjjohn]

8-10 feet? For the barrel, or just the chamber? Because if you mean the chamber, that's going to be one powerful combustion cannon! Usually these things don't have a whole lot of recoil. At least, not as much as you would expect. You could build a stand out of PVC, but make sure it has a large enough base, and if the recoil does prove to be too powerful, just put some weights on it, or use metal pipe towards the bottom of the stand.

[Jeeperforlife]

Thanks for all of the help everyone!

My last (hopefully) question for this build, can I build a stand for this thing out of PVC? Or is the recoil too much for it to hold?

I plan on an overall length of about 8-10 feet.

It can be done. here is a picture of my coaxil on a PVC stand. It is more than strong enough and you could easily add 1" wooden rods to increase the sturdiness quite a bit.



The gun is 4" PVC chamber 5' long and a 5' 2" barrel. Shot at about 135 PSI on average. It does kick pretty good but the stands flexibility helps to absorb it. With me standing behind it I absorb some recoil too.