6mm mag fed full auto

[sagthegreat]

if u have time could you post a picture of the rubber washer where the bb squeezes through

[evanmcorleytv]

if u have time could you post a picture of the rubber washer where the bb squeezes through

Hey.. I know that you're new, but PLEASE don't bring up old threads!!This thread is two years old, just send the author a private message

[sagthegreat]

srry ok

[Gun Freak]

For Christ's sake Evan, it was a relevant inquiry! You're not a moderator, you're a noob, stop going around acting like you're the king of the forum or something.

Sag, I think the rubber washer he used is inaccessible, but I may he wrong. Essentially it's a rubber washer squeezed in a threaded fitting.

[wyz2285]

stop going around acting like you're the king of the forum or something.

It is a old thread, and normally people are against kicking up old threads, even through it´s revelant.
Now, to answer your question:
You can use a 5.5mm ID tube(depends your ammo) to cut a hole in a washer, then cut the OD of the washer until it fits.