Page 2 of 2
Posted: Sun Mar 04, 2012 8:18 am
by sagthegreat
if u have time could you post a picture of the rubber washer where the bb squeezes through
Posted: Sun Mar 04, 2012 10:28 am
by evanmcorleytv
sagthegreat wrote:if u have time could you post a picture of the rubber washer where the bb squeezes through
Hey.. I know that you're new, but PLEASE don't bring up old threads!!This thread is two years old, just send the author a private message
Posted: Sun Mar 04, 2012 11:38 am
by sagthegreat
srry ok
Posted: Sun Mar 04, 2012 12:10 pm
by Gun Freak
For Christ's sake Evan, it was a relevant inquiry! You're not a moderator, you're a noob, stop going around acting like you're the king of the forum or something.
Sag, I think the rubber washer he used is inaccessible, but I may he wrong. Essentially it's a rubber washer squeezed in a threaded fitting.
Posted: Sun Mar 04, 2012 1:07 pm
by wyz2285
stop going around acting like you're the king of the forum or something.
It is a old thread, and normally people are against kicking up old threads, even through it´s revelant.
Now, to answer your question:
You can use a 5.5mm ID tube(depends your ammo) to cut a hole in a washer, then cut the OD of the washer until it fits.