Page 2 of 2
Posted: Fri Jul 05, 2013 8:11 am
by cstru18
Awesome job
can't wait to see the overall finished project.
Posted: Fri Jul 05, 2013 1:56 pm
by Gun Freak
MrCrowley wrote:Haha your voice has gotten a lot deeper since you were last here
Using an airsoft barrel was a good idea, I might have to give that a go at some point too.
Wasn't that long ago... lol
Airsoft barrel's aren't too expensive, here's where I got mine:
http://www.airsoftgi.com/product_info.p ... ts_id=5818
@mark.f and cstru18:
The breech loader is finished! I'm about to edit and publish the video then I will post it here.
Posted: Fri Jul 05, 2013 10:09 pm
by Gun Freak
Video done. It's extremely long and detailed just for those special few of you, Crowley
Here is my new video:
[youtube]
[/youtube]
Edited to embed.
Posted: Sat Jul 06, 2013 5:49 am
by Zeus
[youtube]
http://youtube.com/watch=KGC3xaEjHBs[/youtube]
Very nice, I'm getting into a fair bit of airsoft myself, got a hammer valve in the works too.
Posted: Sat Jul 06, 2013 8:54 am
by Gun Freak
Zeus wrote:Very nice, I'm getting into a fair bit of airsoft myself, got a hammer valve in the works too.
I'm listening
Posted: Sat Jul 06, 2013 5:49 pm
by mark.f
Nice bolt, although I wonder why you did away with the rotation lock when you moved the "handle" towards the front?
But, incredibly detailed work as always.
Posted: Sat Jul 06, 2013 7:28 pm
by Gun Freak
mark.f wrote:Nice bolt, although I wonder why you did away with the rotation lock when you moved the "handle" towards the front?
But, incredibly detailed work as always.
Thanks! The reason is this: when the rotation lock system was on, nothing limited the plunger from coming all the way out. Plus, the whole thing was kind of unstable and fidgety even with my center spacer on the rod. And, I had that spring loaded bolt on the barrel just begging to be used, which I have been wanting to implement on my bolt action system for a while now. So, with that hooked up, loading is a straight shot backwards and the o-ring is kept from coming out the back by the limitations of the bolt movement. It's quite a joy to use
Posted: Sun Jul 07, 2013 3:42 am
by Zeus
It's nothing exciting mate, just a 2240 style hammer valve set up for practical airsoft use and power, instead of the usual 600fps with pellets.
Also working on a clever little sampling system using a solenoid, but I'll stop hijacking and post something if it works.
Posted: Sun Jul 07, 2013 9:28 am
by Gun Freak
Sounds cool 8) homemade valve? what type of barrel?
Posted: Mon Jul 08, 2013 8:09 am
by Gun Freak
Bump for pictures added to opening post
Posted: Mon Jul 08, 2013 9:28 am
by Zeus
Homemade valve is a given considering my new capabilities haha.
The other valve I'm designing is a mongrel breed of a QDV and blow forward bolt, the solenoid smacks it forward, air pressure opens it fully while also feeding a BB into a standard AEG hopup. Power is adjusted purely by air pressure. Barrel on both counts will be an ER-hop EDGI 6.03 509mm. Or maybe just a Prommy and I'll open it up for the hopup myself.
Posted: Mon Jul 08, 2013 10:33 am
by Gun Freak
Sounds sweet man. Post it up when you make some progress!