Page 2 of 2
Re: Hammer valve winchester.
Posted: Mon Nov 04, 2013 3:46 pm
by dart guy
i think that you should put on a fore grip to protect your chamber as well as to make shooting more comfortable you should also think about making some stun darts for that in other words a plowdart with a flattened head, so far i have been able to break a 3/4 inch piece of wood with one using only breath power.
Re: Hammer valve winchester.
Posted: Mon Nov 04, 2013 5:26 pm
by jrrdw
dart guy wrote:i think that you should put on a fore grip to protect your chamber as well as to make shooting more comfortable you should also think about making some stun darts for that in other words a plowdart with a flattened head,
so far i have been able to break a 3/4 inch piece of wood with one using only breath power.
I'd like to see that on video...
Re: Hammer valve winchester.
Posted: Mon Nov 04, 2013 8:35 pm
by Gun Freak
Didn't know we had the big bad wolf on Spudfiles...
Re: Hammer valve winchester.
Posted: Mon Nov 04, 2013 10:05 pm
by Gippeto
dart guy wrote:..., so far i have been able to break a 3/4 inch piece of wood with one using only breath power.
Re: Hammer valve winchester.
Posted: Wed Nov 06, 2013 4:29 pm
by dart guy
it did take about 2 or 3 shots from like 12 inches but i got it,and i really not sure if i can do it again i haven't played with my blowdarts in a while,also i was shooting with the grain not against it , just remember a penny is 3/4 of an inch.
of course i do have a about 70 cal blowdart gun.