SpudFiles

IF you make any attemp to have ANY SORT OF FIRING RATE then combustion might melt PVC!!!

BAD IDEA

iv got a small combustion powered bb gun, it has a fair bit of power with any projectile with a smaller diameter of 10mm. its a 50mm combustion chamber theat is about 180mm long.its a lot quicker 2 load than my Pneumatic all u do is poor in about 5ml of mytholated spyrits amd shake it up to vaporise it u normaly get 5 shots provoding u shake it between each shot, BUT IT HAS NO WERE NEAR AS MUCH POWER AS MY PNEUMATIC (AND MY Pneumatic IS JUST A 2L COLA BOTTLE WITH A HALF INCH BALL VALVE SCREWED ON IT )

DOES ANY ONE KNOW HOW TO MAKE A GOOD Pneumatic ?

owen95 wrote:iv got a small combustion powered bb gun, it has a fair bit of power with any projectile with a smaller diameter of 10mm. its a 50mm combustion chamber theat is about 180mm long.its a lot quicker 2 load than my Pneumatic all u do is poor in about 5ml of mytholated spyrits amd shake it up to vaporise it u normaly get 5 shots provoding u shake it between each shot, BUT IT HAS NO WERE NEAR AS MUCH POWER AS MY PNEUMATIC (AND MY Pneumatic IS JUST A 2L COLA BOTTLE WITH A HALF INCH BALL VALVE SCREWED ON IT )

DOES ANY ONE KNOW HOW TO MAKE A GOOD Pneumatic ?

How do you define a good pneumatic? Power, size, efficiency, accuracy, looks or ergonomics? It depends on you're preference, everybody has I different idea. I suggest you take a look at the pneumatic showcase and see what you like, the base a design off that.

By the way, welcome to the forum!

God dammit three year old topic bump.

Have a look around the showcases, but in the future try not to gravedig. (however we do want a zombie apocalypse.)

inonickname wrote:God dammit three year old topic bump.

Have a look around the showcases, but in the future try not to gravedig. (however we do want a zombie apocalypse.)

Damn, I missed the fact it was a dug up thread.