Page 2 of 3
Posted: Wed Dec 20, 2006 1:15 am
by squeaks
I'm not dumb insomniac, I know barrel sealers can have o-rings. I have one right now with o-rings. I just was saying that since it didn't it had to be a barrel sealer. If it has o-rings it could be either or, but a chamber sealing one NEEDS o-rings.
Posted: Wed Dec 20, 2006 5:37 pm
by noname
A chamber sealing piston doesn't necessarily need O-rings, there just haven't been any without them.
Posted: Wed Dec 20, 2006 5:46 pm
by squeaks
Okay noname, if your so smart, how are you going to make a chamber sealing piston without o-rings. Don't be stupid, it's the only way to separate the pilot from the barrel.
Posted: Wed Dec 20, 2006 5:51 pm
by Insomniac
I wasn't saying you were dumb squeaks, I just misunderstood what you said. What you said was right, I just didn't read carefully enough.....and I suppose that makes ME the dumb one lol
Posted: Wed Dec 20, 2006 7:35 pm
by MrCrowley
noname wrote:A chamber sealing piston doesn't necessarily need O-rings, there just haven't been any without them.
that made me crack up,but you are right, we just need someone to invest time and moeny into a chamber sealer without O-rings
Posted: Wed Dec 20, 2006 7:38 pm
by squeaks
Might I reiterate, HOW!!! You can't keep the pressure back without 'em.
Posted: Wed Dec 20, 2006 8:17 pm
by MrCrowley
I dunno, why don't you find out,it was a joke.
Posted: Thu Dec 21, 2006 12:15 am
by noname
Seriously man, I could make one to hold like 5 psi with some sheet rubber and a barrel sealer.
Posted: Thu Dec 21, 2006 12:53 am
by turbohacker
if the pison is a tight enough fit it shouldn't need o rings just some good thick greese to help seal and lubricate
Posted: Thu Dec 21, 2006 4:23 am
by sgort87
No. Doesn't work that way.
PVC pipe is not perfect. It has many bumps on the inside and you will never make a piston that can seal on the inside and is able to move without o-rings.
Honestly, is it all that hard to stick some o-rings on there?!
Posted: Thu Dec 21, 2006 5:32 am
by MrCrowley
well....If you don't have a lathe/table saw etc and have no time to use a file,you shouldn't build a chamber sealer
Posted: Sat Dec 23, 2006 3:49 pm
by Dan003400
Who is Mr. Bolton?
Posted: Sun Dec 24, 2006 5:11 am
by Dan003400
who is mr bolton?
Posted: Sun Dec 24, 2006 6:59 am
by rna_duelers
Wait a QEV is a chamber sealing piston valve and it doesnt have a O-ring,or is it barrel sealing?Im not sure but if it is then there is your answer
.
Posted: Sun Dec 24, 2006 11:18 am
by nicholai
its a barrel sealer without o-rings, Its actually more like a diaphragm valve but the phragm is like a flexible cone with a flat spot as a sealing face