Page 2 of 2
Posted: Fri Jan 19, 2007 10:39 pm
by chevy08racing
when you mod them, you have to connect the valves to one blowgun, but instead of a blowgun, you should use a ball valve. they would open faster, for better performance.
is this true???
Posted: Fri Jan 19, 2007 10:45 pm
by judgment_arms
Indeed, modded sprinkler valves are much better.
Posted: Fri Jan 19, 2007 10:51 pm
by killagorrila99
Pretty damb good. But you dont need the hose on the fron of the chambers. I found another way of how both chamber fill up at the same time.
Posted: Sat Jan 20, 2007 5:08 pm
by chevy08racing
no i know that modded valves are better but is it true that running the modded valves air hose line to a ball valve is better than running it to a blow gun?
Posted: Sat Jan 20, 2007 11:46 pm
by killagorrila99
Yes. Much better. Faster for your design.
Posted: Sun Jan 21, 2007 10:31 pm
by Hayseed_Andrew
Whats the way without the hose then, do tell..
Posted: Mon Jan 22, 2007 2:34 am
by killagorrila99
Well you only need to fill up one chamber and it will go through the hose on top of the sprinkler valve, go into the next valve, go through the equalisation hole and fill the chamber.
Posted: Mon Jan 22, 2007 8:45 am
by medievalman
yes, that would work, but it might be kinda slow...
Posted: Mon Jan 22, 2007 4:48 pm
by zeigs spud
yea been done before, no reason why it wouldn't work.
Posted: Wed Jan 24, 2007 11:58 pm
by turbohacker
mabee for faster acuation you could put a modded 3/4 inch sprinkler valve