Page 2 of 2
Posted: Wed Feb 14, 2007 11:43 pm
by Killjoy
yeah but doing that could result in some dripping into the valve, and usually thats a bad thing.
Posted: Wed Feb 14, 2007 11:48 pm
by paaiyan
Not if you do it right. Take a thin roll of paper and stuff down into the crack a bit and it'll keep it from dripping down. Or you could just use 5-minute epoxy, set the gun on it's side so it can't drip down and rotate it every half minute so it doesn't all slither to one side.
Posted: Thu Feb 15, 2007 12:09 am
by imforcedtodothis
i could just mix the epoxy normally then thickly coat the outside of the pipe and inside of the valve tube. i could just hold the vale so the epoxy would drip towards the end.... would this work?
Posted: Thu Feb 15, 2007 12:11 am
by paaiyan
umm... Probably. It just wouldn't look as clean.
Posted: Thu Feb 15, 2007 8:56 pm
by sjog
It's a barbed fitting why are you going in side?
Pressure hose-- rubber --then the rigid barrel
Posted: Thu Feb 15, 2007 11:52 pm
by imforcedtodothis
i'd rather not have a hanging barrel...